Start A Conversation by Logging in or creating an account

Vanilla 1.1.4 is a product of Lussumo. More Information: Documentation, Community Support.

Bottom of Page

Water Baths > Troubleshooting Water Baths  »   How do I calibrate?

1 to 1 of 1

  1.  
    • CommentAuthorJohnM
    • CommentTimeJan 6th 2009 edited
     

    Typical Example:  My set point is 37C and my display reads 37C but my thermometer reads 39C? What do I do?

     

    Answer: You press and hold both up and down arrows for 5 seconds until you see the outside decimals points flashing. This puts you in calibration mode. Now press either the up or down arrow until the display matches your reference thermometer.

1 to 1 of 1

  1.  
 

Discussions| Categories| SearchTheme by Vent Swap

Site designed by Outlier Solutions • ©2012